DSP4YOU PWR-DSP1 Manual de usuario descargar pdf (Pagina 18)

PWR-DSP1 User Manual

Page 18 of 23

Copyrights DSP4YOU ltd

Filter type provided include:

o Butterworth (BW): 6/12/18/24/30/36/42/48dB

o Linkwitz Riley (LR): 12/24/36/48dB

Cut off frequency ranges from 10 to 20kHz in 1Hz increments.

4.2.3.8 Amplifier control

The output control panel gives access to all output controls including:

o Gain: 0 to -100dB of gain control

o RMS meter: Shows the dBFS reading inside the DSP

o Delay: 0 to 9ms

o Compressor Limiter with controls for Threshold, Ratio, Attack time, Hold time, Release time, Bypass

o Load monitoring with real time power usage

4.2.4 Audio Video Bridging (AVB) stream configuration

This section applies to PWR-DSP1 enabled with the AVB option. Contact DSP4YOU if you did not purchase the AVB

option and would like to enable it.

While the PWR-DSP1 AVB configuration requires limited setup, the following section will only highlight steps involved in

building/deleting an AVB stream. Please refer to the

AVB primer for the basic terminology used through out this

section.

4.2.4.1 Build a Stream

Click on the “Configure AVB Stream” button to access the following dialog box.

To select one Talker

for configuration,

drag & drop action

as shown by green

arrow

To select one listener

for configuration,

drag & drop action

as shown by green

arrow

Digital Output gain control

Comp/ Limiter metering

Shows amount of attenuation

Output mute

Polarity Invert

Real time power

usage monitoring

Output delay (0-9ms)

Bypass Comp/ Limiter

Comp/ Limiter chart

Typical Comp/Limiter settings

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Comentarios a estos manuales

Sin comentarios

DSP4YOU PWR-DSP1 Manual de usuario Pagina 18

Comentarios a estos manuales